Should you drill and attach bricks?

Brick Brick - Tips on Drilling in Bricks

Brick Brick - Tips on Drilling in Bricks


Brick is such a beautiful material that you often do not dare drill holes for example to put a trellis on the house facade, hang a chalkboard in the chassis or attach a door hook to the garage wall.

Finally, however, win the reason and give the cling up a necessary support, break the uniformity of the well-being and ensure that The garage door no longer strikes marks in the cartoons. And if you have just drilled and plugged correctly, you also have every reason to be satisfied with the decision.

It's not harder to drill and fix bricks than other hard-worked materials, but technology differs a lot. Plugging is a must. Although using hardened nails, normal nailing is not suitable.

The method can transmit transverse forces, but hardly any major longitudinal forces, for example, nailed brackets release bricks when tensile forces add.

In comparison with concrete, brick more porous and thus not as strong. This means, among other things, that you can crack a brick if, for example, plugs are too close to one edge.

The brick wall is also easily located near a very heavily busy street, vibration from heavy transport over time allows even plugs to simply shake off.

It is important that you consider extra carefully before beginning to brush in bricks.

Drilling technology

It is difficult to make an invisible coating if it would be compulsory.

It is possible to make bricks in bricks with such a tool as a plug drill, but it is both easier and safer to use a low-speed

If the tile is particularly porous you can start with a smoother drill steel and increase the dimension if necessary. Then you do not risk the hole getting too big.

Always use a spiral drill with a hardened cutter. Common wood drill steel is meaningless. Also note that it is the machine to do the job: the hole should be drilled, not pressed.

Attachments

In general, the same types of attachments are used for bricks such as concrete, such as pin screwdrivers and the like - but plugging and simpler plastic plug can also go well, provided that the fittings are not exposed to dehydrating heat.

For heavier fasteners, use an M-anchor, a metal screw threaded screw or a PS-anchor, which is also a metal plug with a screwdriver and expanding shields.

Hole Tilt

A very important detail to consider when plugging a brick is to check the wall or the wall consists of full tile or hole tile. In the latter case, one must check as far as possible that the entire attachment does not end up in a cavity.

Tips!


A very simple and inexpensive way of attaching a nail or hook of clearer dimension in bricks is as follows: Drill a thin hole and stuff it full with wet cotton. Drive the cotton plunger as hard as you can and then hit the nail or hook. When the cotton dries, it extends extensively and provides a good grip.


1. To drill and attach a tile screw, use a soft rubber plug.


2. Nylon plug of this kind fits both whole and hole tiles.

3. Without plugging it is very difficult to judge the carrying power of, for example, a hook. A classic example is the X-hook. which is said to hold 10 kg per pin. In actuality, the load power may be less than half.


How to drill


1. Select where to drill the plug hole. Never drill so close to the brick that the stone is burst when the plug expands.


2. Always drill the plug hole at right angles to the wall. If you tap a small water pass on the drill, you are sure.



3. It is important that you use a drilling machine with a stroke function. Also set the machine at the lowest speed.



Video: Drilling into Brick|

Share

Comments