What do you need to keep in mind when setting up stamped wallpaper? Here you will find tips and description of how to do when you set up a pasted wallpaper.

Set Up Stamped Wallpapers - How To Make

Set Up Stamped Wallpapers - How To Make


In addition to standard paper stacks, there is also a fairly large assortment of sticky wallpaper. The advantage of these wallpapers is to avoid sticking can and brush. Many home-cutters with a little habit of wallpapering think that pasted wallpaper is easier to work with. The sticking is the only difference between putting up ordinary wallpaper and setting up stamped wallpaper. Otherwise, the technology does not differ in any way. In order for the wallpaper to succeed, it is important that the substrate is completely smooth. Therefore, tear away all loose wallpaper and grind all old wallpaper shards.

If there is damage to the wall surface, you must also fix them. Use fine-grain filler and flush back the irregularities. Then grind with fine grained slip paper after it has dried. If you are going to dress a painted wall with wallpaper, it is important that the surface is completely clean. Wash with ammonia solution and rinse clean water for several seconds. If the surface is glossy, you can rub it easily with fine-grained slip paper. Previously untreated walls of sheet material should always be splashed. Strong suction surfaces - such as particle board - should be ground with diluted wallpaper adhesives. Otherwise, the adhesive on the sticky wallpaper will be sucked up from the surface and the wallpaper will loosen.

The meaning of pasted wallpaper is, of course, saving time and making the work easier. One part of the efficiency is to cut the walls for one whole wall at a time and roll them together for soaking in the wood. In order to make sure you know the length of the wetlands, you should measure very carefully. Add about 5 cm to the wet cutters dimension.

If the wallpaper requires pattern matching, add the pattern report. Also, number the warnings if it is necessary for the pattern fitting to be correct. Before starting the set on a wall it is important to mark the wall of the wall evenly. You can do it easily with the help of a lot - for example a scissors in a string and a pen.

If you do not have access to a wallpaper, the pasted wallpaper is easy to work with. You simply pull up the waves directly from the wood and put them on the wall. You can also work more traditionally and fold the soaked tapewats toward the middle and allow the paste to swell a few minutes before setting up the wallpaper. Choose working method based on habit and space. Most wallpapers should be bordered or with only one millimeter overlap. The exception to this rule applies to wallpaper in the corner.

Tools:

Water drop, Tumstock, Pen, Solder, Spackelpade, Wallpaper knife, Wallpaper brush .
1. Measure and cut to the walls to one wall at a time. Do not forget to take into account the pattern report and about 5 cm cutters.


2.Read the waves one by one with the front of the wallpaper inwards. Fill the water droplet with water and place the container on the wallpaper.


3. Lower the rolled-up layer. Slowly pull out the wall on the wallpaper. Always hold on with the other hand on the roll.


4.Wrap the two ends of the tapewater together, back to back. Then let the wet rest for a few minutes before putting it on the wall.


5.If ​​you do not have a wallpaper, you can also put the wet in place directly from the tray. Then place the wood on the floor next to the wall.


6. Hold the tapewater firmly with both hands and pull it slowly upwards. Put the tapewater in place starting at the roof angle.


7.Use a wallpaper brush to rub the wallpaper. Be careful with this moment to avoid irritating air pockets on the newly painted surface.


8.When all the weather is in place, the wallpaper should be cut clean at both the roof angle and the floor. Cut with a wallpaper knife and use a wide-flap as an anvil.




Video: Wallpaper (1963|

Share

Comments